1993 Jeep Grand Cherokee "negative battery cable" Questions

Ad

Question about Jeep Grand Cherokee

2 Answers

negative battery terminlas hold both cables do not touch the battery both cables touch them together and hold for 5min. then reconnect battery start engine codes cleared id it a hard code it will come

Ad

battery negative (-) post. B. Disable the engine so it will not start when it is cranked. (Ground the ignition coil wire, or disable the ignition circuit or fuel pump relay.) Limit cranking time to 15

Ad

Question about Jeep Grand Cherokee

1 Answer

...negative battery cable and connect a 12V test light between the battery negative post and the negative battery cable terminal the light will burn if there's a draw. Make sure all electrical consumers ...

Question about Jeep Grand Cherokee

1 Answer

negative battery post,and the other end of the negative ground of the jumper cables,to the engine,anywhere that is a good ground,then try and start it,if it starts,then the ground cable on the jeep,is

connector (4). Remove the pressure sender (2). To install: Install oil pressure sender. Connect oil pressure sender wire. Install front splash shield. Lower vehicle. Connect the negative battery cable

pressure sender (2). Oil pressure sending unit To install: Install oil pressure sender. Connect oil pressure sender wire. Install front splash shield. Lower vehicle. Connect the negative battery cable

...negative battery post an the negative battery cable end , with the negative cable disconnected from the battery. If you see more amps draw then it should have , pull fuse till it goes away ! How To ...

Question about Jeep Grand Cherokee

1 Answer

...battery cable (negative, then positive). Press and hold brake pedal for at least 30 seconds (ensures no residual voltage in system). Reconnect battery cables (positive, then negative). Start and run. ...

Question about Jeep Grand Cherokee

1 Answer

...negative battery cable and then remove the fuel tank cap to release fuel tank pressure. Remove the fuel pump relay from the PDC. Start the engine and allow it to run until it stops. Select any ...

negative battery clamp until last. If the problem persists, either the solenoid (if separate) needs replacement or, if integrated with the starter, it may need replacement. Starters draw a huge amount

Not finding what you are looking for?
1993 Jeep Grand Cherokee Logo

2,177 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Mike

Level 3 Expert

4372 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14852 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...