...pressure. If cups are replaced, remove them with wheel hub cup remover D80L-927-A and bearing cup puller T77F-1102-A or equivalent. To install: If inner or outer bearing cups were removed, install ...
...washer behind the axle nut, but I don't see one...it feels like it is really locked-on there. Thanks in advance! Dave They are fitted very securely into the axle. It will come out as it is just ...
...washer onto the bearing and then screww the tensioning nut on by hand until it stops. At this point you want to take a 10 inch adjusable wrench and tighten don the bearing slighty and easily until it ...
...Pressure Hose 3 3F780 Power Steering Cooler and Hose Assembly 4 3504 Steering Gear 5 5005 Frame Plug ends of fluid lines removed and ports in gear to prevent damage and entry of dirt. Remove two (2) ...
...washer by tightening the lock-nut within 15?30 degrees. Turn wheel hub several times in both directions. Wheel bearing should be seated correctly. If necessary, measure wheel bearing preload. NOTE: ...
...pressure and with a quick ****. The spindle nut will grab the rear bearing and seal as you pull the rotor off and come out at the same time. Step 6 Install the bearings into the new rotor. Grease the ...
washer from the bolt and rethread the bolt back into the camshaft. Using a 3-jaw puller and the relief holes in the sprocket, remove the intake camshaft sprocket. Repeat this procedure for the exhaust
cotter pin Brake disc to the axle hub with the matchmarks aligned. Install the 2 screws and tighten the screws to 48 inch lbs. (5 Nm). Brake caliper to the vehicle and install the 2 bolts. Tighten the
222 questions posted
Usually answered in minutes!
102 Questions
83 Questions
41 Questions
42 Questions
45 Questions