...turn signal flasher is located on the back of the turn signal switch assembly, remove the steering column shroud by removing the 3 screws on the underside, then look on the back of the switch for the ...
...turn signal not working, Inside right turn sig. very fast. I think it might be the flasher. Where is the flasher located in the car. This would indicate that the front indicator bulb is burnt out and ...
brake lights don't work replaced bulbs, lights work, turn signals work, brake lights still won't come on? Check your fuse.
Left turn signal will not shut off,why Faulty switch in the steering column.
Question about Chrysler Cirrus
...Started up this morning fine went and did something started fine, next time nothing did not even turn over not a hint, everything works but the wipers, turn signals and radio checked all fuses,
...the crank sensor on my chrysler cirrus 1996. the factory alarm reset itself. i had previously turned it off. cut the volume wire so lights just blink and makes clinking noise. i can start the ...
signal from the coolant temperature sensor affects the computers fuel injection amount. Could be too lean or too rich. When a coolant sensor first starts to go bad the engine will be slow to start the
Question about Chrysler Cirrus
...turn signal on passenger side goes real fast. I replaced complete back light and still doesn't work. Checked fuses and they are ok.. Did you check voltage and ground wiring for problem brake lamp? ...
Turn signals and wiper do not work. How can I fix? I have replaced wiper/signal fuse. Did you chack the fuse/
...of when you pull it out, That is the Turn Signal/Hazard flasher relay, There also my be two of them in Fuse Panel. pull both out and replace there not very expensive.Hope this Helps, Good Luck
361 questions posted
Usually answered in minutes!
391 Questions
244 Questions
193 Questions
168 Questions
124 Questions