1993 Chrysler Town & Country "eatx sensor" Questions

...eatx relay, they are both good. I have also checked the continuity between the wires of the tcm connector and the shift solenoid connector. All eight wires have continuity. Please help. THERE MUST BE ...

...the two sensors, it would be the one on the right. P700 = PCM has a transmission code in the EATX controller, and P0731= Gear ratio error in 1st. Replace the output speed sensor and clear the

...sensor in 2000 b2500 Mazda automatic transmission truck is automatic but have pull down to 1st gear to get it to pull its self There are several sensors and solenoids in the transmission. Check the ...

code 15 eatx relay output always off...transaxe don't shift...A technician find the error code 15. Replace your input and output speed sensors on the trans. The reason why it won't shift is because ...

...I replaced speed sensor and EATX Relays. The slots for them were empty but they are wired inside. I didn't know if maybe the last mechanic may have sabotaged it. Its a 3.0 engine. Selector or ...

...sensor or I don't think it is a solenoid can you help me. It produced a code of p0700. Thanks In a Jeep, OBDII code P0700 indicates that the EATX (Transmission controller) has an active fault and has ...

...that probably needed to be replaced. It could also be an electrical problem. Check the fuse(EATX) and make sure you have power and ground at the transmission

...Sensor Heater Circuit, could be dirty or loose wires or just stop working. Usually you have 4 of these under your car so check all. Fault Code P0700 Message: Here's what my service manual says: EATX ...

...wiring harness Location front of tranny @1. Red wire from solenoid pack and 2. red wire from TCM/EATX and 3. Wire from the EATX relay locate and check for clean . and check the ground strap to the ...

...keep coming up every time i check the car codes 1684 Battery has been disconnected within the past  50 starts.P700 EATX Controller DTX presentP160 Neither rich or lean is sensed at the O2