...and put front lobes of camshafts in position shown in picture with cam gear timmed up at same point cam gear are 3:1 ratio look closely at cam gears in pic to see front lobe positions for both ...
...camshaft removal. Remove the intake manifold and valley pan, if so equipped. Remove the rocker covers, and either remove the rocker arm shafts or loosen the rockers on their pivots and remove the ...
Question about Cars & Trucks
...down my 2005 Hyundai Santa Fe 3.5 engine and my son decided to clean the garage. In doing so, the camshafts were placed in a box in no order. There are several numbers on each camshafts. Also,
...camshaft lobe. Position the rocker arm(s) over the push rods, then install the rocker arm seats. Tighten the rocker arm seat retaining bolts to 44 inch lbs. (5 Nm). Final-tighten the rocker arm ...
where is the camshaft located in a 2004 pt cruiser The camshaft position sensor on an 04 pt is located on the right side of the engine, towards the top (looking at it from the front), directly in back
Question about Cars & Trucks
what should be the position of the camshaft lobes in installing another cylinder used cylinder head? Usually the camshafts are marked on the gear end with some sort of mark (according to the make and ...
...the camshaft it self... the camshaft on these cars have a screw on lobe at the end. lots of times(every one i have worked on) it comes loose and causes the code when the end part spins out of
...lobe position to the position where the timing belt can be installed at the smallest possible angle in order to prevent intake and exhaust valve contact. Camshaft sprockets rotation Do not turn the ...
Question about Ford Cars & Trucks
...camshaft lobe 1. You would not want to mix say valve 3 into position of cam lobe 1. The two surfaces have different wear patterns. Also valve spring tension is to be measured on each valve after ...
Timing marks of mazda etudes 160i b6 model 1999? Crankshaft Key facing Up.....Camshaft positioned with #1cylinder intake and exhaust valve rocker arms on the heel of the Camshaft lobes...Both valves ...
594 questions posted
Usually answered in minutes!
832 Questions
814 Questions
819 Questions
720 Questions
623 Questions