1992 Jeep Wrangler "intake manifold" Questions

Ad

...intake use a common gasket. When reinstalling the exhaust manifold, there are two guide pins, one front of the manifold and one in the rear. What usually happens is that the manifold sits ON these ...

Ad

...intake manifold. This process lowers the peak combustion temperature and helps combat the formation of Nitrous Oxide (NOx) in the exhaust. Difficulty: EasyInstructionsThings You'll Need:Needle-nose ...

Ad

Question about Jeep Wrangler

2 Answers

...intake manifold and vacuum hose. Bad Idle Air Control Motor (IAC) Low compression (170 psi + is OK) Start cleaning and repair these trouble spots and see is there any improvement. ==== For more ...

Question about Jeep Wrangler

3 Answers

...intake manifold and vacuum hose. Bad Idle Air Control Motor (IAC) Low compression (170 psi + is OK) Start cleaning and repair these trouble spots and see is there any improvement. ==== For more ...

Question about Jeep Wrangler

1 Answer

intake manifold is loose or has come off. The line is on the side of the intake manifold toward the firewall reconnect the line and secure it with a zip tie. Hope this help I see this all the time its

...the inline 6 engine. The intake manifold gasket was replaced because a shop said it had an intake leak. Take it back to the same shop. Warrantee? check your vacuum lines they may be hooked up

Question about Jeep Wrangler

1 Answer

...a chip 2 it called mind blower Intake air temperature sensor is usually located about six inches or so behind the throttle body. It screws right into the top of the intake manifold and has two

Question about Jeep Wrangler

1 Answer

...intake manifold is the common culprit for this.  It may look like it is flush to the block, but it isnt and is causing a huge vaccum leak.  There are two locating dowel pins that the ...

Question about Jeep Wrangler

1 Answer

...The IAT sensor islocated in the front sensor on the intake manifold it has a grey 2 wire plug that is the 4.0.if it's the 2.5,the sensor is in the back sensor on the manifold. Thank you for using ...

intake is lining up fine but the exhaust is off by about 1/4 of an inch in the way of a bolt. Was hoping for some solutions, left disappointed. take the manifold off try not to brake your spark plugs,

Not finding what you are looking for?
1992 Jeep Wrangler Logo

498 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...