1992 Jeep Wrangler "brake pedal" Questions

Ad

Question about Jeep Wrangler

1 Answer

...brake pedal hold the pressure on the brake pedal when opening the bleeder then push the brake pedal to the floor keep it there, until you tightened the bleeder, then pump the brakes up and hold it ...

Ad

...the emergency flashers are engaged. Fuse in the fuse box is ok. I checked everyone. check the brake switch. It sits above your brake pedal. Just follow the brake pedal arm up and you can't miss

Ad

brake pedal lever. Easy to replace if you are a handy fellow. Disconnect battery ground cable. Disconnect electrical connector for stop light switch. Remove bolt and lock nuts attaching brake pedal to

Question about Jeep Wrangler

2 Answers

...brake pedal i have a 92 jeep wrangler.have replaced everything from brake booster to the pads,shoes have replaced all the lines on this also.have bled the brake system of all the air.still i have no ...

Question about Jeep Wrangler

2 Answers

...brake pedal will slowly sink to the floor. On early 2000 vintage Chrysler products you need to check brake lines as they have been known to rust (and fail catastrophically) my guess you mean? pedal ...

...brake pedal goes all the way to the ... 98 wrangler - brake pedal goes all the way to the floor. The master cylinder and all brake lines are free of leaks. I'm not losing any brake fluid anywhere. I ...

...switch on the brake pedal for your brake light prob. There are 2 wires on the switch, one is 12 volts and the other gets 12 volts when you step on the brake pedal. You can check tis with a test

...brake pedal for a fuse or switch. I did and have no idea what to look for. Can somebody help with a solution. hello sounds like a bad or loose wire on your brake switch up under your dash follow your ...

...brake pedal several times with the engine stopped, hold pressure on the brake pedal and start the engine, the pedal should move down a small amount if the booster is working ok, if not check there is ...

brake pedal is depressed but 1.5v from either pin to ground when the pedal is not pressed.Is this my short to ground and how do i trouble sshoot it? It is a drain on the battery and I would be looking

Not finding what you are looking for?
1992 Jeep Wrangler Logo

498 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...