1999 Audi A6 "blower fan resistor" Questions

Ad

Question about Audi A6

2 Answers

A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa!! Check your blower motor fuse as the high fan runs on a separate fuse than the other fan speeds

Ad

fan blower only works on high speed (4) not on any lower speeds New fan blower resister was installed 2 weeks ago. solved problem then but now problem is back this is caused by the blower resistor as ...

Ad

...blower fan resistor which is located on or next to the blower fan assembly under the passenger side dash in the footwell. if resistor is bad, there will be no fan speeds. make sure you are getting ...

fan electrical connector 4.remove the blower resistor 5.remove the blower motor downward and to reinstall 1.install the blower motor 2.install the blower resistor 3.connect the electrical connector to

...insofar as how to replace the blower motor and why the blower motor's wires have to be twisted...even with the new blower motor fan. Best of Luck, "00 Buck" "Still living on the Right Side of

...blower fan. If you missing the ground on the blower fan connector than most likely it is the blower fan resistor (controller), it is located under the hood close to back firewall behind left cylinder ...

...blower motor resistor most resistor blocks bolt to the fan housing, be causes its air cooled and must be near fan actual so it always is cooled. see? i just looked,its there. dead center blower ...

When the blower motor is drawing too much current it burns out resistors for lower fan speeds in resistor block, but doesnt blow fuse for fan. Also check for leaves and stuff in fan when removing fan

...blower fan on, fan does not work. Prior to completely going out, fan would quit working intermittently. Is this a fuse problem? Any tips on diagnosis would be appreciated. Chk for power at the blower ...

blower motor fan is controlled by the blower motor resistor.Its the resistor which controls the fan on respective speed which you select.But if the resistor goes faulty,then it will not be able to set

Not finding what you are looking for?
1999 Audi A6 Logo

652 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2000 Audi A6
2000 Audi A6

458 Questions

2001 Audi A6
2001 Audi A6

374 Questions

2002 Audi A6
2002 Audi A6

332 Questions

1996 Audi A6
1996 Audi A6

179 Questions

1998 Audi A6
1998 Audi A6

172 Questions

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14842 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...