...drive shaft inserts into the splines of the tail shaft. The shaft connects to the rear end where the power is divided between the rear tires through through a diferential. The axels connect to the ...
...drive shaft I recently put new u-joints in the drive shaft. Now I have transmission fluid leaking and dripping from the front U-loint on the drive shaft. the rear seal on the tail shaft must have ...
...drive shaft vibrating Where the drive shafts join in the center the "rubber boot" seems to be bad. Both shafts have alot of movement when I push/pull on the shafts. The vehicle vibrates at ...
...drive shaft still! I have a 1996 GMC Sierra and I recently put new u-joints in the drive shaft. I noticed tranny fluid dripping from the front u-joint and posted the problem on this site. I was told ...
Question about GMC Sierra
Why do you here a clank when you put it in reverse i changed both u joints on the drive shaft please help The connection between drive shaft and transmission. The part is shaped like a plus sign.
Question about GMC Sierra
...in engine until they do then drop dist you may have to turn the rotor backwards about a tooth when you start to drop whn the cam and dist gears mesh it will line up oil pump drive shaft to dist ...
Question about GMC Sierra
...pump then remove cap mark rotor pointer location for install indexing then remove drive pin onshaft that hold drive gear on mark gear to put on the same way remove shaft replace sensor ...
drive shaft suppose to spin when 4 wheel is not engaged ? I can push the button and tell that it goes into 4 wheel but was not sure if the front shaft is suppose to be spinning even though not engaged
...drive shaft u-joints,or cv axle drive shafts in front if its 4 wheel drive,block the wheels and put the truck in neutral,to release any tension on the drive shaft,go underneath,grab the driveshaft a ...
...drive shaft by hand and listening for any rough spots. It could be a carrier bearing or a bad U joint too. Isolate it by dropping the drive shaft and turning the pinion yoke by hand. If there is a ...
393 questions posted
Usually answered in minutes!
987 Questions
847 Questions
676 Questions
601 Questions
604 Questions