1993 Ford Ranger SuperCab "oil near back engine" Questions

oil sending unit is the switch that tells the gage what pressure to read. its located near rear of engine passenger side, should be a single wire connector black in color. a easy way to look for it is

...oil pump pulley. Ford did not put a 2.5 in a Ranger, maybe a 2.3 ? 2.3 = 3.0 - The CMP sensor& synchronizer/shaft are located behind the intake manifold (i.e., back near the firewall on a Ranger) ...

...near idle) on dirt road it would die. But always cranked right up. Done this about 3 or 4 times within a year. Mechanic said he replaced fuel filter, he said has good fuel pressure. Said something ...

...near the oil filter on the four cylinder engine. Look back behind the intake plenum near the firewall on the 6 cylinder. what engine , why not post that> V6? or I-4, and what size. with that real ...

replace oil pressure switch oil pressure switch Usually located on the back of the intake near the distributor or near the oil filter depending on the engine size.

...is a oil pressure switch at the back of the engine leaking ,or the valve cover gasket is leaking near the back of the engine , have the engine steam cleaned then you will see where it is leaking

...$10 item. You should change it. The location of the PCV is on the top (or near top) of the valve cover. Replace it and the oil/smoke will reciculate back to the correct path (back to the valve

Location of oil sending unit Car starts beeping to stop engine low oil pressure usually in the middle in the very back of the engine on top..some are near the oil filter .. check both locations

...oil dipstick tube also near that be careful open the right one transmission dipstick tube shorter than oil dipstick tube you have to open shot one if you have good look you can see it's going to ...

...oil near rear of block. At that time plenty of oil pressure...I was driving to get it checked and noticed I had no oil pressure. Returned home with no problems. The oil sneding unit is back there on ...