2003 Ford Taurus "key switch problems" Questions

Ad

...key and place in the ignition switch then you will kick in the theft mode and that also has to be reset at the dealer.. Now you do not have to buy the switch from Ford, you can take that in but note ...

Ad

Question about Ford Taurus

1 Answer

...key position. The A/C clutch doesn't seem to be engaging with switch. I have checked all fuses, relays in engine and passenger compartment. Replaced ignition switch, also. Cannot find problem. the ...

Ad

...the sounder comes and goes. If so, replace the ignition switch, there was a problem with these on Fords for years. Some of them got to the point where you could turn the switch without the key in

...switch grounds the starter relay and allows it to operate. Does the starter relay connector have 2 powers? One constant and one with key on/cranking? If these power supplies are there, suspect the ...

...switch out..turned key and no sounds of pump working. Confused is this a switch problem or what? Could be a bad switch. Use a ohm meter to check each switch position. Use fuel pressure gauge to test ...

...that should hep you i have seen this happen when the radiator colling fan was hot weird otherwise the key switch is not the same as the ignition switch which is further down the steering ...

Question about Ford Taurus

1 Answer

...key switch that can give you problems such as this. Usually if it is the key switch, you will have other electrical problems, such as main power to dash and computor will accure. I would start with ...

...the ignition switch is the cause of this problem, I think there is a recall, this is not the ignition key lock cylinder but the electric switch it operates through a linkage rod when u turn your

...switch when the key is turned to start. If that brown wire is not hot with the key turned fully, the switch or the fuse is bad. If there is power all the way thru to the relay but the relay does not ...

Question about Ford Taurus

1 Answer

...switch? Place key in ign. lock n tumbler and turn to "on" position. Under the column you'll see a small hole to put a small screwdriver or rod into and press it in. While you're pressing it, pull the ...

Not finding what you are looking for?
2003 Ford Taurus Logo

1,790 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1999 Ford Taurus
1999 Ford Taurus

2,348 Questions

2001 Ford Taurus
2001 Ford Taurus

2,262 Questions

2000 Ford Taurus
2000 Ford Taurus

2,120 Questions

2002 Ford Taurus
2002 Ford Taurus

1,869 Questions

1998 Ford Taurus
1998 Ford Taurus

1,431 Questions

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...