2001 Dodge Neon "replace front wheel bearing" Questions

rear wheel bearing replacement http://www.ehow.com/how_7776197_change-neon-front-wheel-bearing.html hate to do that, but i have a word limit.

front bearing need to know how to replace The bearing in pressed onto the hub. Remove the wheel, remove the cotter pin and the great big nut on the axle stub. The whole shebang, bearing and hub, ...

front first. Chalk the rear wheels or set the emergency brake. Put the transmission in neutral. Jack up the left side of the car. Grab the coil spring and rotate the tire by hand. If you can feel/hear

...front tires make a sqeaking noise when I accelerate at any speed. It also sounds like a clicking noise. I did have my brakes replaced in the past. Im not sure what if could be. Please help. hi..the ...

...front wheel. It sounds like I am running over a rumple strip. I noticed the tire was worn so I had it replaced. The sounds still persits after putting on a new tire and gets louder the faster I go or ...

replace the rear wheel bearings in my 2004 dodge SX 2.0 Remove the wheelcover.Loose but do not remove the lugnuts on the wheel. Jack up the vehicle enough to free that wheel from the surface it is on.

replace heater core. I have quite a few issues with my car. I like the neon and want to work them out. I replaced a wheel bearing and need another now. I have a bad wheel cylinder in one of the drums.

replace the hub assembly. I would first jack up the front end and try to wiggle the tire from top to bottom, if there's some movement, there's a good possibility that it is the bearing(just don't want

...front of vehicle, block rear wheels to prevent rolling. Remove covers and exhaust pipe section under oil pan. Drain oil. Remove oil pan and oil pickup assembly. Remove rear main cap carefully and ...

WHEEL BEARINGS ORTIE ROD END. I KNOW ITS NOT THE AXLE CAUSE IT AIN'T CLICKING WHEN I TURN. AN I JUST PUT NEW STRUTS ON IT, WHAT IS THIS NOISE ? Coould be your ball joint. One way to check to see if it