1987 Ford Ranger "87 fan" Questions

Ad

Where are the timing marks on 87 ford ranger 4 cylinder If you open the hood and look down behind the fans there is a pulley about six inches in diameter. This will have notches running along te edge ...

Ad

87 lb-ft).NOTE: When replacing low oil level sensor, use a new metal gasket with a rubber O-ring. Install low oil level sensor. Tighten sensor to 20-34 Nm (15-25 lb-ft).Install transmission inspection

Ad

Question about Cars & Trucks

1 Answer

...87 and get the fan to run. If I jumper from 87 to any other pins the fan does not work. I'm not sure of where this leaves me. Please help. Thanks If you see pin 87 you must see 30 ! 30 should have B+ ...

...on relay shows #next to pins)with key on check for power at pin hole 85 or 86.You can also put jumper wire from pin hole 30 to 87 without key on fans or fan should start(keep fingers out of fan

fan quit on 87 celebrity, heat ac, etc.. fuse ok ???? 87 Chevy Celebrity fan (blower) for ac heater etc.. qiut, fuse is good, worked fine yesterday died today... Hi Check for bad connection at heater ...

...87 terminal goes to the fan itself so that the output of this terminal will be a grounded motor waiting for voltage. The 86 wire on this relay is normally fed through the fuse box via the fuel pump ...

...87 Acura Legend sometimes works and sometimes doesn't. The fan also runs on occasion and not necessarily when the ac is supposed to come on. The system has Climate Control. I've checked and cleaned ...

...fan 87 is power out (normally open pin with 87a being normally closed part) 85 and 86 are the relay coil pins (that energize it) and you should have power and ground to those pins (only when car is ...

Question about Ford Ranger

1 Answer

87 .If fan is good it will run . Do you know how relay's work ? VEHICLE RELAYS Operation Diagnosis The PCM controls both relay's by supplying a ground to energize the relay . Is the check engine light

...87 an the fan should run , if the fan motor is good an there is battery voltage at pin 30 ! Pins 85 an 86 are the control side of the relay ,pin 86 should have battery voltage an pin 85 is from the ...

Not finding what you are looking for?
Cars & Trucks Logo

842 questions posted

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...