1986 Ford Bronco II "set timing 86 2" Questions

...the timing specs for the ignition Ignition should be set to 5 degrees ( +/- 2 degrees) Before setting ignition timing, be sure to disconnect and plug vacuum hose to vacuum advance unit on

...timing should be set at for a 1986 chevy 4.3 motor pickup truck half ton 2 wheel drive short bed Timing at idle (degrees BTDC) 0 federal and 4 California (chapter 5, page 183, Haynes Chevy and Gmc ...

...to change the 3piece timing set that sits behind the water pump, then have a mechanic set the timing with a timing light. I have found that the newer carbs aren't as good as the older-made

...timing was off and set it to specs (he never test drove it...), drove it around block and had him put it back. Took it to another mechanic, he said it needed fuel injector system flushed and cleaned ...

...86 chevy one ton pickup brakes work great when first start out then pedal goes down over half way when it warms up and brake light comes on; but stll stops. then leave parked for a while and the same ...

...86 its a carb. if a carb you really need to say so as many a mech never seen one. today. gone now for 27 years. 87 to present. i cut teeth on carbs. in 60s a love/ hate thing,,, today i have fancy ...

...86 pontiac fiero? Neihbor ask me to replace her fuel filter, just trying to save some time hope this helps first disconnect the fuel pump and run the car till the fuel system is emptied--you will ...

86 chevy s10 blazer 4x4 2.8 I have a 1986 Chevy S-10 Blazer 4x4 2.8 and when I reach about 55 to 60 mph. the whole truck starts to shake bad. I replaced the u-joints and the passenger side front axle.

...set, engine started, vehicle speed less than 75 mph, system voltage over 10.0v, ECT and IAT sensors from 39-86ºF and within 16ºF at startup, BARO sensor over 75 kPa, fuel level from 15-85%, ...

...set for a few minutes. Look for notable water line towards the bottom of the jar. Spark... as a test, regap all the plugs .010 to .015 less than specification. If it regains power, then it's a poor ...