2001 Ford Explorer Sport Trac "5 temperature sensor" Questions

...temperature at the cylinder head. (The ECT is located in the intake manifold.) These should read within 5 or 6 degrees from each other at all times. If it is determined that the sensors are all ...

...Temperature (IAT) Sensor. 4. If the voltage on the GY/RD wire shows above 0.1v, locate and repair the high resistance between the MAF sensor and pin #91 of the Powertrain Control Module (PCM) ...

temperature sensors located in the seat cushion heating elements. heated seat relay. Do both front seat heaters not work ? Do you know how to test electrical circuits with voltmeter ? PINPOINT TEST J:

...Temperature Sensor - Lower Left Here's auto 1 - Mode Actuator 2 - Recirculation Actuator 3 - Blower Motor 4 - Blower Motor Control Module 5 - Air Temperature Actuator 6 - Evaporator Temperature ...

...5  Exhaust gas recirculation temperature sensor  3  6  EGRC-BPT valve  3  7  Closed loop control  3  8  Closed loop control  4  1  Air ...

...5 Engine coolant temperature (ECT) sensor 6 Crankshaft position (CKP) sensor 7 Camshaft position (CMP) sensor 8 Knock sensor 9 Heated oxygen sensor (HO2S) (front, LH) 10 Heated oxygen sensor (HO2S) ...

...temperature sensor, 5-cylinder Jack up the car. Remove protection cover from under engine. Drain the coolant. Lower the car. Release coolant hose from thermostat housing using pliers. Remove ...

...temperature control sensor for open. Is there 5 ohms or less? Yes No SERVICE Circuit 470 (PK/BK) for open. RETEST system. GO to B5 . B5 TEST CIRCUIT 470 (PK/BK) FOR SHORT Using an ohmmeter connected ...

...5-volt reference signal is sent to the sensor and the signal return is based upon the change in the measured resistance due to temperature. Fig. 1: The IAT sensor is located in the air cleaner outlet ...

...5-volt supply circuit between governor pressure/temperature sensor harness connector terminal "A" and transmission solenoid harness connector terminal No. 2. If resistance is less than 5 ohms, go to ...