...new clutch and pressure plate, replace throwout bearing, put transmission and bell housing back in, connect shifter linkage and clutch cable or hydraulic, put drive shaft back in and you are
...new clutch i have a R reg 1.2l ford fiesta which has just had the clutch replaced. drove it on the motorway at 70 going up a slight incline in 5th where it was struggling slightly and my foot was on ...
new clutch(disk, pressure plate and throw-out bearing).If you find that there "is" excessive movement of the master clutch unit, you can run some self threading 1/4 inch hex head screws about 3/4 inch
Question about Ford F-150
...new clutch kit , and the fly wheel resurfaced but the truck has a soft clutch and bucks and jumps taking off in 2nd gear Check your motor and transmission mounts. Not much into the slave ...
Question about Ford F-150
...new oil in, and r134a. The clutch will not engage, i have power at low and high switches, i checked the ohms and they are both closed.. I am not getting power to the clutch, I checked the fuses, and ...
...new switch, you'll know it goes in, very easy. good luck my truck had the same problem what happens is over the years there is a diaghragm inside the clutch master cylinder it will leek so you wont ...
...new rad cap, its a 1985 5.0 liter, fuel injected,2/wd auto,appox 165000mls,replaced waterpump 2yr ago. thanks for knowledge and time I think you have a blown head gasket, getting oil in the water is ...
...and what else could this be? your clutch is a hydrolic style and adjust its self im sorry to say your clutch is probily out again. whas the fly whell resurfaced and a new pressure plate ...
Question about Ford F-150
...new on as very stiff is this a ok and let it work it self in or no Fan clutches are stiff and loud till vehicle runs a bit, as fan clutch mechanism warms up drag on clutch mechanism releases pressure ...
...new clutch disk and pressure plate. You'll need to use the clutch alignment tool, which should come as part of your clutch kit. If your clutch kit doesn't include this tool, you can buy it at ...
1,267 questions posted
Usually answered in minutes!
2,636 Questions
1,214 Questions
1,298 Questions
1,160 Questions
1,038 Questions