2003 Ford Focus "zetec belt tensioner" Questions

...zetec 1.6 makes a sqecking noise - i sprayed the belt with WD40 by the alternator and the squecking stopped. Then a loud rattleing noise started whenever I rev the enging or it goes over 1500 revs. ...

16v zetec (old shape) and i was wondering at what stage the timing belts should be changed? ford say the same old get out ****,"when signs of wear apparent....."CHANGE IT AT 80K MAX with the tensioner

...belt 2000 ford focus If it's like mine,the ZETEC engine,I'd wholeheartedly recommend letting Ford do it.They only charge 185 dollars labor and will do it right.  In my shop manual,it ...

...Belt ?2.0L Zetec-E Removal Raise and support the vehicle. For additional information, refer to Section 100-02 . Remove the splash shield. NOTE: For vehicles with 1.4L and 1.6L engines and equipped ...

...zetec engine then its quite simple ,just slacken and remove the fan belt by turning tensioner with a spanner clockwuase and this will release the tension so belt can be slipped off.then their is one ...

zetec 1.6 03 plate but the air bag light on the dash keeps illuminating what could be causing this? Common fault on FORD Usually due to a poor connection in the YELLOW PLASTIC CONNECTOR underneath the

belt tensioner on my 2001 ford focus (zetec engine) but i need to find out what size socket i need to take it off. i'm pretty sure it's metric since i tried a 7/16 and a 3/8 standard and the first was

...belt for a 2000 ford focus 16 v zetec and how the fan runs on polley?picture show. Things You'll Need:Wrench set Jack Jack stands Socket set Ratchet 1/2-inch drive breaker bar 1 Open the hood of your ...

...zetec on a y reg 2000 for cambelt renewal (you need a set of timing tools to do this)you need to place timing pin in engine block located drivers side just above the sump you need to set pistons at ...

...belt, on how it is put on over the right pulleys, [ showing how it suppose to be put on correctly] Hi there! As a general rule, fit it over grooved pulleys, then bring it over the tensioner pulley to ...