...3 and at 4 there should be 12V. if you have no voltage or no change in voltage between 1-2-3 you may have gotten a bad resistor, as has happened to me more times then I care to remember. Be sure to ...
...--- Radio Ground 7 --- Orange (thick) --- Black --- Radio 12V Harness 3 1 --- White --- Green --- Speed sensor 2 --- (not used) 3 --- (not used) 4 --- (not used) 5 --- (not used) 6 --- (not
...blow 1: fuse 12 good. 2: switch heater /on off. 3: high, med,low speed, use high, its direct. 4: the blower, one of those points has no 12v on high, use a simple voltmeter to find the failed
Question about Ford Cars & Trucks
...12v from the battery a permanent earth and then probably 3 more wires, a return signal from the motor to the wiper delay module that tells it when to park and your 2 speed switches from the column- ...
...12V/batter voltage applied to it, when on lets say speed number 3 the blower gets less voltage thus resulting is slower operation. put 12V/battery voltage to the blower motor directlly and ...
3 :bad switch, 4: bad fan, (hot wire fan does it work,. yes, good its good. id put my DMM across the fan , turn it on, and if 12vdc is across said fan, and it dont blow, its a bad fan. if the low side
...12v directly onto it the fan runs. The connecting loom from the car has 3 wires. Black, Red and a smaller cable which a assume run through the switches. Should any of these cables have voltage on or ...
...3 gear and runs well if power is lost can switch motor off and it resets but light engine light stays on after a couple of days engine light will switch off. log on to kiausa.com Very good site with ...
...3 speed fan switches does nothing when turn on car set to heat and push fan control it does nothing Check your fuses by removing them one at a time but be certain to remove the battery before you ...
3,146 questions posted
Usually answered in minutes!
3,749 Questions
2,612 Questions
1,226 Questions
897 Questions
840 Questions