1984 Ford Mustang "motor oil" Questions

1984 mustang 5.0. Where do I add oil if is motor oil take valve cover top of usually is on the left side of motor trany oil pour down where the dip stick is use a funnel good luck

...motor run with the oil at the proper level if its loose or a broken O ring on the filter you will see the oil coming out if so change the filter and tighten till a good snug fit is achieved (2) the ...

...motor up alittle, that will give you enough clearance to drop your oil pan. If you try and replace the timing chain cover without dropping the oil pan, you will more than likely wind up with an oil ...

...motor mounts and jack up the engine to removed the oil pan. Then remove oil pickup, then remove the two bolts that hold the oil pump on. Clean all gasket the surfaces, use new gaskets and sealer and ...

...it? With out pulling the engine out you need to take the motor mouts loose rise the engine as high as you can drop the oil pan out the back you might have to take oil pump or oil pump pick up tube ...

...oil, a head gasket is probably leaking. Worst would be cracked motor block. There is also transmission fluid in the Radiator if you have a Water cooled Automatic transmission. The Radiator has 2 ...

...motor oil (Bad Bad) Check for leaks in the heater core inside the car and see if the rugs are wet. Check radiator for discoloration in the fin areas and tank areas. Finally check your radiator cap, ...

...oil pan gasket There is no simple way.. I have done it with the motor in and out.. It took less time to pull the motor and change the pan than it did to drop the cross member , undo the engine and ...

...capacity for a Ford 351 Windsor motor including the oil filter. If it is a factory car pan 5qts, Drain pan, add 5qts, run 5min check oil. http://www.sansaworldmp3.com/

...motor in it. I has a terrible knocking sound. We replaced the main bearing and timing chain. It doesn't sound like it is coming from the can shaft. The knocking sounds like it is coming from ...