1989 Ford Ranger "rear abs" Questions

rear ABS only" your sensor is most likely out or on it's way out, it is located in the rear differential. that's your abs problem. Next which engine do you have and what is it doing how and when as it

...rear abs speed sensor. Is that a diy job? This isn't hard to do at all really and should be easy to procure the part from the local parts store. There is only one little screw holding it in Raise and ...

...ABS. I replaced the brakes on all four wheels and the rear wheel cylinders. The rear brake lines were open individually for a very brief time, and bled conventionally. I would like to know if I still ...

...ABS Rear brakes lockup Rear brakes lockup especially on wet pavemant sounds like you need to replace the wheel cylinders also check brake shoes and adjust properly upon reassembly i have a 94 ranger ...

...abs unit to get fluid to rear brakes again Replace the broken line then, you must bleed the entire brake system , each wheel works by itself on these cars, . Put the rearend in the air get the tires ...

...on the brake pads making them grab or it could be the abs system itself.. There is a speed sensor on the rear axle which also controls the abs.. That can be changed easily and isnt too expensive.. ...

...Rear End? My ABS Light came on and a loud whining noise is comming from the back of the truck. Noise isn't all the time, Just when Driving at a constant speed or accelerating. When Decelerating the ...

...ABS on rear wheels only. can not get fluid to rear brakes.Lines not plugged. Disassembled and cleaned ABS valve,air will pass through,so why not fluid. reset spliter valve by pushing in on black ...

why is my speedometer still not working after changing the rear abs sensor ? My abs lite went off though Probably a broken speedometer cable.

...ABS sensor mounted near the rear axle. When I opened the cover, I found a lot of corrosion. I scraped out what I could and sprayed it down liberally with some electrical contact cleaner. I did not ...