1989 Ford Crown Victoria "hook wires tower" Questions

...wrong direction. The diagram shows the rotor spins counterclockwise in the firing order. If it was hooked up reverse, you may have one or two cylinders fire, the rest are a jumbled heap of unburned ...

...hook up the # 1 wire to the # 1 coil tower to the # 1 plug or cylinder,follow the fireing order 123456,its simple if you cant see coil tower numbers look at another car with same engine that has ...

hook up plug wires on coil 3.8 pontiac if you haven`t started replace one wire at a time and you won`t need a diagram for this.you can also go to the library and get a book for your car that will show

...wires Code 301 means cylinder one is not producing power. Problem could be ignition, fuel, or mechanical. If compression is good on all cylinders, check the fuel injector. Do you have spark at ...

hook 12 volts to the positive terminal and a wire from the neg to ground. Have a high voltage wire from the coil tower to 1/4 to 1/2 inch from ground. Open and close the power circuit . You should see

i have no spark your coil is shot. check the coil [email protected]. could be the wire not hooked up going to the distributer as well. i can not remember the engine if it has a distributor or not ...

Hook your AC voltmeter probe to battery positive, start the truck, and push the other probe into the back of the ECM connector at those wires. The ECM may be in the engine compartment by the passenger

hook either jumper cables or a power pack. These are not made to jump start the car, but will provide power to pop the trunk to get you to the battery. Lift the bonnet of the car and on the right side

...hook up tester to check spark. Trying to trace my way back to find what is wrong with spark. Trying to check for voltage at ignition coil electrical connector but not sure what leads to connect to. ...

...on one bank left or right and to the coil towers with a white marker.or a card board template with numbered positions for the wires to hook up to the correct towers. Or just change them one at a