1990 Ford Thunderbird "removal tool rear seat" Questions

rear passenger seat by removing the base of the seat, and seeing if you have a round circular plastic cover with 6 cross head screws, if you do not have this then you will have to remove the fuel tank

tool during removal, as they could cause personal injury. Remove the shoe-to-anchor springs, using Brake Shoe R and R Spring BT-11, or equivalent, then unhook the cable eye from the anchor pin. Fig. 1

...Tool Number Safety Belt Bolt Bit T77L-2100A NOTE: Safety Belt Bolt Bit T77L-2100-A should be used for safety belt removal and installation. Removal Remove rear seat cushion. Refer to Section 01-10 . ...

...Tool) to dislodge the pushpin retainer at the rear edge of the Trim Panel approximately 4? down from the top, pry Trim Panel toward the outside of car to release retainer. for more help click this ...

from the hangers. Pull the rear seatback out of the Grand Prix, preferably with the help of an assistant. Is there anything else you need?if you need an auto tool you can click here: great tools  

...Removal Procedure Remove the rear seat. Refer to Rear Number 2 Seat Replacement or Rear Number 2 50-50 Seat Replacement in Seats. Remove the Third Pillar trim panel. Refer to Third Pillar Trim ...

...removal. 6.) Remove the three bolts from the bottom edge of the rear seat-back, using an 8 mm socket wrench. One bolt is in the center; the other two bolts are on either side. 7.) Pull the rear ...

...rear seat in a towncar I need to find out how to remove the bottom rear seat in a Lincoln towncar 2005. Need to get under it to get a camera piece that fell through the seat belt hole. The rear seat ...

...rear seat and what kind of tool do/may I use to do so? There isn't much available on how to do that as they are not part of normal operation. My guess is that underneath you will find bolts that you ...

...tool will locate between rear seat,this will close and lock rear cover Make sure both sides of rear cover lock,get friend to press down Once rear cover is locked down,remove tool,and check opperation ...