...4 pins in the relay. two is for energizing it . and two for the contact that will close once the relay is energized. jump these pins for the contact, your fan should run. if it did not and there is ...
...relay. How many Volts need to be at the fan for operation, when the gauge in the cockpit said Hot, there was about 005 volts at 3 of the 4 wires to the fan, of course the 4 wire was ground and there ...
...connect to battery to test fan. (Be sure to keep fingers out of the fan cause it will bite you) If fan works and you have replace the relay you check to see it there was power to the relay. You will ...
pin 4 of solenoid pack was missing. this voltage Comes from pin 46 relay 28 on fuse panel aft of aircleaner. this 12v comes to the relay pin45 supplied from fuse 17, and is turned off
...4: Jumper Pin 3 & 5 on the LEFT relay (drivers left) (please remove relay first). This should turn the wipers on, regardless of whether or not the computer is telling it to run. If wiper does not ...
...4 days, is because something stayed on. That is what you are hearing when you attached the good battery. You must find out what it is and turn it off, or you will keep losing batteries. Since nothing ...
...pin with a little wire wool. Now check the coolant. First put the interior heater on maximum heat. Run the engine up to working temperature and then squeeze all rubber hoses to help shift any trapped ...
Question about Ford Thunderbird
connect a fused jumper wire between ground and PCM 32-pin connector "A" terminal No. 3 (Blue wire). Turn ignition on. Using vacuum pump, slowly apply vacuum to EVAP 2-way valve as illustrated. See Fig
188 questions posted
Usually answered in minutes!
523 Questions
505 Questions
431 Questions
394 Questions
202 Questions