2004 Dodge Ram 1500 "put rear spider gears" Questions

rear end, changed axle fluid and put new gasket, no chanege in noise, now what while you had the cover off did you by chance look at the condition of the ring gear and spider gears...if it was run for

...rear axle the spider gears fell out of place. How can I place them back in It's not easy to put them back, but if you get the side gears in position with the axles bumped out as far as you can, the ...

...rear drive axle to replace studs spider gears fell out having trouble installing gears back into place gears jam into inner housing not enough clearance removed axle again checked clutches in back of ...

rear of the truck. When I make a left or right turn, it throughs its self out of the drive gear but i can put it in reverse just fine. It a automatic transmission also. When im driving down a straight

...rear tire the ring gear will turn,look for a bolt head on the spider gear housing pull out that bolt/pin and then push axle all the way in there will be a c clip on the end of the axle pull that out ...

...rear end. It still makes a clunking noise when I put it in reverse. What could it be When I put it in reverse it makes a clunking sound. When I put it in First gear it kind of pings the "backlash" ...

rear end, You will see it fall out. Then just pull the axel out. When you put the axel back in, push it all the way in then slide the c-clip over the end of the axel and then pull out on axel and that

...rear axle on a 1993 chevy pickup? On yours, you need to remove the diff cover, remove the small retainer bolt at the end of the spider gear cross shaft and remove the shaft. push the axle in and ...

up the rear end putting in neutral with front wheels blocked with motor turned OFF and turn the drive line slowly to find out if U joint or Ring and Pinion Gear or Spider Gears in the rear end are bad

rear is elevated and put in gear does not jump upon braking. Are going to try front rotors next but does not jump when front is not rotating. No cracked drums. check front motor mounts. Hold brake and