1997 Dodge Ram 1500 Club Cab "crankshaft sensor" Questions

Ad

...sensor and Crankshaft position sensor Replaced the two sensors due to a DTC pointing to the Crankshaft Postion Sensor. Now truck is hard to start and is putting out the 4 new DTC codes. Do I need to ...

Ad

...crankshaft sensor is faulty. The sensor is mounted in a fixed position in the engine block. The tip of the sensor protrudes into the crankcase at a distance of 0.05 plus or minus 0.02 inch from the ...

Ad

Question about Dodge Ram 1500

1 Answer

...crankshaft sensor for a dodge 1500 Ram 3.7L Hello Porter The Crankshaft sensor is mounted into the right rear side of the cylinder block just above the oil pan. It is positioned and bolted into a ...

...Sensor and/or the Crankshaft Position Sensor is tight. Note: Refer to any technical service bulletins that may apply. Were any problems found? All Yes ® Repair as necessary. Perform the ...

Question about Dodge Ram 1500

1 Answer

CRANKSHAFT SENSOR I recently put a new engine in my 1998 Dodge Ram truck, I keep getting a code that reads crankshaft positioner loss, when I bought the motor the flywheel was already on and lined up,

Question about Dodge Ram 1500

1 Answer

...fine until about 4000 rpm then sputters. Same when driving only at lower rpm. P0339 is Crankshaft Position Sensor A  CKT IntermittentP0335 is Crankshaft Position Sensor A  CKT ...

Question about Dodge Ram 1500

1 Answer

...change that and if still nothing then change the camshaft postion sensor that sensor tells the computer that the 1 piston has came all the way up and it tells the crankshaft sensor to do its ...

where is the crankshaft position located ? where is the crankshaft position sensor located ? front of the engine down low.

...5.7 crankshaft sensor pigtail eaten by rats now truck won't start,turns over will it run with harness unplugged? No, you need to repair the wiring or it has no way of knowing where the crankshaft ...

Question about Dodge Ram 1500

1 Answer

...crankshaft position sensor is located on the same side (right) but is at the opposite end of the engine between the bell housing and the block. The crankshaft position sensor can be replaced without ...

Not finding what you are looking for?
Cars & Trucks Logo

1,050 questions posted

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...