...put it back together I through the truck out of time by putting the distributor in a tooth off on the gears, so I adjusted it back into time, but now it is still giving me trouble! First it said that ...
...2 wheel drive from 4 wheel hi i put my 99 chevy s-10 blazer from 2 hi to 4 low this morning to get out due to bad weather, when i got to the highway i put blazer in neutral and pushed 2 hi button and ...
put it back together an now the anti theft kicked in an the car will only run for like 2 seconds an the theft light just stays on it dont blink at all i have tryed the 10 min test plus the 30 min test
Question about Chevrolet Lumina
...2 or 3 bolts holding it take the bolts out turn on your truck and remove it like you would if it was a cap in the inside should spin if doesent then thats another problem it wouldn't be your mounting ...
...put new vacuum switch in transfercase and vacuum accuator under the battery. Also a new dash push button switch. Problem is the dash switch lights up when I turn the key on or start it, but then all ...
...2.4L, it died on the road while my wife was driving. Some numbnut tried to jumpstart it and hook up the cables wrong... So far I have replaced the bettery, starter, ignition switch, and engine ...
...2 screws under where handle is located. A Phillips screw driver removes the door handle cover. Pull on door panel to pop off, whole process takes under 5 minutes. If motor works and no power to motor ...
Question about Chevrolet Lumina
...PUT BACK OOPS RADIO GOES DEAD. dang 2: PULL ALL IOD FUSES. THE PCM MEMORY FUSE ONLY. Ecm F29 IS IT(MEM) (PCM) 10AMPS ALL DTCS NOW GONE, STORED. THE DATA FELL; INTO THE BIT BUCKET AS THEY SAY IF ALL ...
...put them back in or let them touch "ground" during the test. LAST: 2. The wire near the dome assembly may be corroded. Remove the dome assembly and let it hang out. The light should go OUT when all ...
933 questions posted
Usually answered in minutes!
964 Questions
809 Questions
639 Questions
448 Questions
418 Questions
