1988 Chevrolet Corvette "1984 starting problems" Questions

cluster was blinking on and off motor started ran it for a while then turned it off tried to start it again but the cluster would not even blink motor just turns over and will not start. it acts if ...

1984 c4 corvette/ trans problem 1984 c 4 corvette automatic 139,000 miles. I didnt drive the car for four months and only started it twice. Now when I take off tranny does not want to shift to second ...

no start 1984 chevy corvette. I think it's a fuel problem I had the same problem and had my mech. change the fuel pump. He said it was easy since you could get at it without removing the tank. the ...

Starter will not turn over when battery is just slightly low. When Battery is charged, starter turns over and engine starts immediately. Problem came out of the blue, had been very dependable, no ...

no start 1984 corvette. Fuel problem on my 88 i swapped the engine for my built motor and later had the same problem, it would crank and spark, the injectors would fire, and the computer was sending ...

1984 corvette, tuned up 12 months ago. Driving the other day started acting like it was not getting gas, finally would not run. Just crank up & cut off. Checked the fuel filter by undoing one end ...

electrical power loss. have new alternator and battery and no other apparent problems. could the ecm cause this. it is 25 years old ha ha!! Does the radio work? Sounds like a switch issue to me, but ...

Fuel system 84 chev. Corvette My two injectors are geting no gas and there is gas in the gas tank. Where is my fuel filter, fuel relay and fuel pump located. How can I test these items to see which ...

1984 Cadillac ELDORADO that will not start. Replaced fuel filter and fuel pump. Are you sure it is not an electrical problem? Spray some starting fluid into the throttle body. If it starts, then it is

1984 oldsmobile delta 88 charging system diagram wiring problems car starts fine i put a after market raido in and some wires got cut that shouldnt have caused my ecm to burn out but i fixed that and ...