Question about Chevrolet TrailBlazer EXT
...39;t get it out of 4 whd Disengaging by turning the control. Stays in 4whd. Cannot get back into 2whd Drive the Blazer in reverse for 200 or 300 hundred meters, then try to disengage, this will work, ...
39;t disengage 4.wheel drive. The push button indicator shows it39;s in 2 wheel, but the shaft still turns. I tried pulling fuses & driving in reverse neither worked. This is my wife39;s truck
...disengage Does dash indicate whether it39;s in 2 wheel, 4 hi,or 4 low?It sounds like it might be in 4 wheel low.With the car running in Park, try turning dash knob from 2 wheel to 4 wheel low ...
...disengage the 4 wheel so you can drive in 2 wheel with no side affects although you would have to replace # 9 or # 23 or bolth to make the 4 wheel work again but then again if you do this it may ...
Question about Chevrolet TrailBlazer EXT
...39;s stuck in 4 wheel drive. How do I get it back to 2 wheel drive? On these issue, there are few solved help links for troubleshooting the issue easily.------- Click the link below: --- No 4x4 light ...
...disengage. After driving in dep mud and water it39;s best to clean this area oput and with no disassembly you can wash this place with a high pressure car wash wand and clear all the mud out but if ...
Question about Chevrolet TrailBlazer EXT
...disengage the Auto 4wd, only to function as it feels. 2. Does not engage 4 Hi or 4 Lo Option, even with a NEW Button panel. 3. Noticeable wet area around the Driver's Side CV Shaft, opposite ...
...disengage the driver39;s side front hub, essentially leaving the truck with half of the front end engaged. How do I fix it? Is it vacuum driven or a solenoid? Your front differential is what39;s ...
Question about Chevrolet TrailBlazer EXT
...4 wheel drive, the front end makes a popping noise when under torque. Is it the hubs, transfer case or both? it could be the hubs are not all the way engaged or disengaged but most likely it39;s ...
...Disengage the locking hubs using your hands by turning the knob on the hubs. Remove the snap rings holding the hub locks in place with the snap-ring pliers. Pull the hub off the axle.3.Install the ...
343 questions posted
Usually answered in minutes!
10 Questions
294 Questions
184 Questions
50 Questions