1998 Chevrolet C2500 "power igniter" Questions

...and then connected the cables to the battery and left them connected for about 30-45 minutes to get power to the computer to get it to reset. I then unhooked the positive cable from the battery, ...

...Starter to a 1966 chevy pickup ignition. large wire on big stud of starter for full time power and the little stud will be where the wire from the ignition goes let me know if you have ...

...out of the ignition You've got a short or the ignition switch is faulty. Run your hand over any power wire to see if you have any hot spots. This is where the short is. Also the starter may be ...

...providing ground to each injector in pairs or individually. The fuel injector fuse provides power to the injectors using splices therefore enabling one wire to feed 6 injectors. A shorted

Truck won't turn on. There's power and starter Truck won't turn on. There's power and starter seems to be doing fine. It appears that there's no gas getting to the egine...and yes it has 1/2 tank og ...

Battery cables touched to wrong post now no power to start key I hope you allready checked the ignition fuse carfully, if so there may be a diode in the circuit which could have poped. A diode only ...

Why I'am not getting spark to plugs? Already changed dist.cap,rotor,plugs and wires,and crank sensor Sounds like ignition module has failed or there is no power to the distributor.

...previously learned voltage code. If the codes match, a class 2 message is sent from the BCM to the powertrain control module (PCM)/vehicle control module (VCM). The message enables the fuel

...who knows how to . Hooking up diagnostic equipment , professional scan tool , lab scop . looking at power an grounds , transmission electronic control module input's an outputs . ECT Transmission ...

...positive wires coming off the positive post. Make sure both are getting voltage. If only one has power you could have the problem of power in the cab but not at the starter. If you have power to ...