1996 Chevrolet S-10 Pickup "96 s10 replacing check" Questions

Turn Signal Switch 96 s10 4.3 vortec Replaced the turn signal switch and still have to do it manual check the flasher

...96 s10 very rough idle when driving smoothes out but as i go to brake or come to a complete stop... i replaced all the vacum lines coil plugs wires o2 sensors iac sensor have you tried repacing the ...

...s10 pickup 4.3 vortex . I have goog fuel pressure . I have ignition .It will run on starting fluid . Injectors will not fire . Replaced spider injectors and crankshaft poisition sensor . replcace ...

...96 S10 and the instrument panel lights and tail lights went out. I checked the fuse and it had blown so I replaced it. When I turned the headlights back on the fuse blew again. There is a clicking in ...

...96 chevy S10, Water PumpRemoval & Installation2.2L EngineTo Remove: Drain the cooling system. Remove fan assembly. Loosen the water pump pulley bolts. Remove or disconnect the following: Drive ...

...96 S10 4x4, power everything, extended cab with the 4.3 motor I have had this truck for five years and it has had a shake every time I use the brakes. Its like a warped rotor. I have replaced the ...

96 chevy s10 2.2l won't start, doesn't have spark. Replaced coil packs and the crank position sensor. Still won't start. I would check your fuses, but from what you have replaced and still not firing.

96 s10 no turn signals or hazard replaced fuse an it keeps blowing it. After fuse replaced my brake lights started working till fuse blown again didnt specify blazer or pick up -----if pick up check ...

...and i need to replace the moter i have a moter from a 1996 chevy blazer s10 they are both 4.3 litter v6 vortex wlii the 96 moier fit thank you check pcm numbers may want computer from host ...

96 S10 4.3 Go to starter and cross it over(w/key on),starts right up,replaced starter.Now same issue again.Turn key get either clicking at relay,or nothing at all,do a few times,then starts right up. ...