1996 Chevrolet Blazer "96 s10 replacing check" Questions

96 s10 blazer idles high and stalls after tune up and replacing spider injector Check the air filter box for fuel lying in it then pull the vacuum hose off of the map sensor and see if any fuel runs ...

...96 s10 blazer that shifts hard from first to second gear when on long distance trips. I got a new green spring from a local tranny shop to install on the valve body but which part of the valve body ...

...s10 blazre with vortec 4x4. I don't know it sounds like you went over this thing pretty good . You did the fuel filter i had to ask but it sounds like a fuel delivery problem . Your fuel pressure ...

...96' blazer and this happened to me as well. Turned out that I was getting the 4 wheel drive checked out because it wasn't engaging and they found that a vacuum hose was loose. The mechanic said that ...

...96 s10 lt blazer First of all the steering coloum is now where near the engine block and the bracket you mention is for the throttle cable and the cruise control cable and has no gasket for any kind ...

96 4.3L Vortec S-10 Blazer died while driving I have been having trouble starting my blazer, it would take forever to turn over in the morning. I had to get the starter replaced 3 months ago, but ...

96 chevy s10 2.2l won't start, doesn't have spark. Replaced coil packs and the crank position sensor. Still won't start. I would check your fuses, but from what you have replaced and still not firing.

96 s10 no turn signals or hazard replaced fuse an it keeps blowing it. After fuse replaced my brake lights started working till fuse blown again didnt specify blazer or pick up -----if pick up check ...

Turn Signal Switch 96 s10 4.3 vortec Replaced the turn signal switch and still have to do it manual check the flasher

96 S10 4.3 Go to starter and cross it over(w/key on),starts right up,replaced starter.Now same issue again.Turn key get either clicking at relay,or nothing at all,do a few times,then starts right up. ...