...sentra xe p1320, p1140 codes car intermittenly looses power, when started in the morning while cold car runs fine until operating temp. Distributer Signal Output is code p1320........Intake Valve ...
Question about Nissan Maxima
Sentra, and Nissans were pretty standard, those two would be the accessory relay on the far left and the ignition relay next to it. The other two relays are the fuel pump relay and the ECCS relay (for
Question about Nissan Cars & Trucks
...Sentra runs fine for about 2 miles then starts losing power and dies wont start back up for about an hour Check Engine Light/Loss of Power Due to Throttle Body Unit ... repairpal.com > Problems > ...
...Sentra Loses Power My 2002 Nissan Sentra GXE (standard trans) used to run fine but now it idles rough and will randomly lose power when driving for no obvious reason. It will usually restart in 5-10 ...
...sentra se-r spec v with 130k When im driving the power cuts off at 2.5RPM. if i switch gears under 2.5, it runs smooth. Also, when i rev the engine in nuetral, it does the same thing. Any ideas? It ...
sentra loses power and dies at stop signs 1990 nissan sentra 1.6 liter engine, 4 speed. will run, but after a few minutes it will lose power, i gotta keep pumping the gas, and it will take off after i
...sentra 1.8l the car powers on but the ignition coil is not getting power to it i was told it can be my computer or my distributor cap..i put new ignition coil new throttle body new fuel pump but car ...
...pack or the distributor. I don't have the wiring diagram for the 2002 Sentra but usually power to the pump is controlled by the distributor.Please feel free to let me know if I can help you
...Sentra gxe Engine has contually lost power over three days ,I have replaced all spark plugs distributor cap and rotor .NOW THE CAR HAS DISTIBUTOR TIMMING ALL THE WAY TO ITS HIGHEST POINT AND STILL ...
Question about Nissan Maxima
...sentra doesn't run smooth over 3000 rpm or if you to mash the gas pedal. It will ideal fine and run fine if you ease on the gas pedal but stumbles when you get up around 3000 rpm. I put on a new ...
1,975 questions posted
Usually answered in minutes!
1,122 Questions
1,007 Questions
857 Questions
783 Questions
480 Questions