2004 Dodge Stratus "front brakes" Questions

front of car shakes when I apply the brakes but stops when I push harder. Shakes again if I have to slam on the brakes you may need to bleed the brakes and clean the rotors of any brake fluid. usually

front disc brakes how do you install the anti rattel clips on the front disc brakes on a 2004 dodge stratus insert clips into caliper bridge, where the pads ride on it.be sure to clean it good and ...

...front disc brakes, rear drums. My dash brake light is on. I can disconnect the wire to the valve and the light goes out. I think it can be reset, but I am not sure how. Please help. the stratus is ...

...brakes, to make sure all of the air is expelled from the system.On Cirrus, Stratus, Sebring convertible and Breeze models, the following wheel sequence should be used to ensure that all the air is ...

Front brakes?? 2005 Nissan Pathfinder, at high speeds, when the brakes are applied the steeling vibrates in my hand. There are a few diffenet things to test. the front rotors could be slightly warped.

...front brakes on 2002 dodge stratus. cost? just need new brakes installed- pads-rotors-labor-- on front I charge 1.2 hours labor ($50-80/hour) to change the pads and rotors. Decent pads are about

2005 stratus squeaks in front end over bumps and car shakes when slowing from speeds of 35mph and over front end squeaks over bumps and even squeaks when I push down on the front end in park. the car ...

...front and back brakes..... so if front works and back does not... 1. Bleed your back brakes...let me know if you need help with that. 2. verify that you have full fluid levels in your reservior(s) 3. ...

...brakes in this order: left rear, right front, right rear, left front just like the manual said. Now the brake pedal is hard when the car is not running, but spongy when the car is running. I am ...

or not. they have 2 different styles on these cars and need to know how to tell the difference If you have anti-lock brakes you should have extra brake lines and a pump in front of the master cylinder