1999 Chevrolet Venture "camshaft sensor" Questions

need to find where the camshaft pos senser is located on the engine. it is a chevy venture 2001 THE CAMSHAFT SENSOR LOCATED ON THE SIDE ENGINE CYLINDER BLOCK NEXT TO POWER STEERING PUMP.

Camshaft Position Sensor "A" Circuit Range/Performance (Bank 1 or Single Sensor)." It is triggered when the powertrain control module (PCM) detects a problem with the signal being sent by the camshaft

...camshaft sensor) after scan. Replace inexpensive camshaft sensor (replacement was somewhat difficult, however, as it involved removal of serpentine belt and power sterring reservoir) and problem ...

...and rough idle several pcodes - po301,cyl 1 misfire p0327,knock sensor p0336 crankshaft position po341 camshaft position any ideas please help Look for broke/ shorted wires on Crank sensor.. ...

where is the camshaft sensor for a P0349 ODBC II code? cam sensor is located on top front of engine.Just in front of lower intake manifold.

...Camshaft position sensor harness or connectors (The sensor circuit is open or shorted) . code B1218 horn relay coil circuit short to voltage battery . IT could be cousin problem with other sensors . ...

reader will take a "snapshot" of the vehicle computer systems when the code p0341 (camshaft sensor) is set.It may be a bad sensor or wiring or connector or computer. Most likely broken wire in harness

...and check all the onnections to sensors such as, vehcile speed control sensor, mass air flow sensor, crankshaft position sensor, camshaft poition sensor, throttle position sensor, etc. Good

...camshaft position sensor and weak crank shaft sensor .When crank shaft sensor gets weak it will stop functioning.When crank shaft sensor stops working then ECM will not control fuel system and the ...

...camshaft sensor, ICM and coils, spark plugs and wires, and it still wont restart after a short or long drive. no issues while running. What else could it be? what kind of oil pressure does it have ...