1998 GMC Suburban "install 4 light switch" Questions

...4 wire connector and 2 wire connector. Now you are holding the old switch and yor troubles have just started the after market replacement switches really **** get a real gm swich.If you look at the ...

...4 ton 5.7 engine, Auto, 4wd (Push Button) The Transfer case has just had a complete rebuild. I have installed a new dash switch for the 4WD, & also a new Contr ol Module (Twice). What it is ...

4 wheel drive will not engage front axle.actuator switch is new and working and transfer case works.I think the lever in front axle is stuck. On the front axle of your Suburban there is a thermally ...

...4 in socket on a 1/2 breaker bar to get these to break. I don't have the exact torque specs to put these back on, but I went about 40lbs on the knuckle bolts and closer to 80lbs on the caliper torx ...

...4 mounting points top left top bottom right and left. next pop off the switch from the front slide a screwdriver at the front leading edge and push it towards the back of the door panel and lift ...

...4 lo button light up when in 4 hi? The TCCM plug isn't corroded at all. Could it just be the cheap aftermarket dash switch that I installed and should I worry about or just drive it? It could be a ...

...4 to the side of road. there was no problem per fog light just when I installed more fog lights to one switch, I'm trying not to have 8 switches on my dash you need to use a heavy gauge wire and a ...

...Install the left sound insulator, connect the negative battery cable and check switch operation. ADJUSTMENT 1988-92 Vehicles See Figures 3 and 4 Fig. Fig. 3: Suggested brake light adjustment tool for ...

...4 wheel drive or the mechanicle part,tested all four light bulbs all test good. I am not sure if there is a switch on the 4 Wheel drive lever under the cover and also not sure of the voltage at the ...

...4: Headlight switch assembly-1996 vehicle shown Disconnect the negative battery cable. Remove the instrument cluster trim plate by unfastening the retaining screws or simply unsnapping it. If ...