2001 Mazda Protege "throttle body" Questions

throttle body Throttle Position Sensor (TPS) !! In response to Zane Gear, the throttle position sensor and the throttle body are NOT NOT NOT mounted to the strut tower on a 2001 Mazda Protege with the

throttle body. Should be two screws holding it on easy to take off and put on. It will be attached to the air horn, which is the device between your air duct and the intake plenum. The cable from your

idle. get so throttle body cleaner and clean the throttle body and spray into the little hole on the side of the butterfly that leads to the iac valve. if that does not work you may have to replace it

throttle sensor How to install throttle sensor on 1993 1.8 portege It is located on the throttle body, it has a 3 wire connector, it is held on with tamper resistant screws, 2 of them.

throttle-body. You must take off the Intake tube to get a good view of it. To replace it I think you might have to take off the throttle-body. Fig. Exploded view of the intake manifold assembly with 2

...throttle body, the IAC, the thermostat, the intake, the battery and disconnected a bunch of hoses and cords. Then I replaced the thermostat, cleaned the throttle body, intake and the IAC and put ...

...u help me.. did ***. and turned up 7 things...what do u think? THROTTLE LINKAGE COULD BE STICKING.ACCELERATOR CABLE BINDING MISROUTED, AIR LEAK AT THROTTLE BODY GASKET.FAULTY IDLE SPEED

throttle body looks like & how to replace it.. The trottle body is located on the intake manifold. There will be a black tube going to it. This tube is the breather tube and on the opposite end is

...throttle position sensor)located on the throttle body. But that has to be testedAlso replacing the Oxygen Sensors closest to the engine,every 80 to 100,000 miles, will give you better throttle ...

...throttle body PCM has failed Engine running; and the PCM detected the TP sensor indicated more than 4.60v (i.e., a throttle opening of 92.27%). Note: This trouble code may set due to an intermittent ...