1985 Mazda RX-7 "check ignitor" Questions

...check ignitor,(swap trail/lead ignitor plugs at distributor) coil, check with ohm meter. Trailing ignitors are very common failures, especially when either jump starting or being jump started when a ...

...line and it is getting plenty of fuel. could the distributor ignitors be the problem or the coils? Check the coils by swapping where they are at and see if that changes ...

check the ign switch use a test light on the coil and put it to sw on coil and turn on to start if light up its ok LET ME KNOW how you get on Ron i would also get a spare ignitor in case on goes 

...filter out of an 88 gxl non turbo13 b that i had setting out back.i called the local autozone and checked the part nos on the pump for turbo and non.they were the same.the previous owner said the ...

...Check power to ignitor, if you have power to ignitor, the ignitor may be faulty, or it's magnetic sensor is at fault.If you do not have power to the ignitor, you need to trace the circuit looking ...

...sidekick"as motor turns over doesng get any fire to plugs.i have changed dist. ignitor had coil checked..only fires with ign. on and plug stuck in plug wire as I plug and unplug the ignitor. 1995 ...

...the chassis while looking for a spark from the high tension lead resting on the engine. You can check the ignitor is getting a signal by connecting a dwell or duty cycle meter to the incoming

...pick-up clearance. If it blinks at the dissy and not at the ignitor the check the wires/plugs for breaks. If it blinks at the ignitor and there is still no spark then the ignitor is the likely

...ignitor or coil assembly is bad. If the Check Engine Light does not illuminate check for a good ground at the thermostat housing. Ground 101 or the ECU is bad. More times then not the ignitor is ...

...check the ignitor to know for sure it isn't the problem and is there some thing else I can check....Thanks I don't think the igniter is the problem, it could be a bad pickup coil in the distributor, ...