2002 Ford F250 Super Duty SuperCab "truck drive shaft" Questions

...drive shaft for my ford f250 4x4 long wheel base rear shaft my old shaft is worn out @the yoke and spline. i would like to know if anyone in Tucson custom builds shafts.i live close by. i changed ...

...drive shaft that is no good..Look under the truck at every one and look for rust next to the caps..Also look at the mid shift bearing that is in the center of the rear drive shaft.It is bolted to the ...

...drive-shaft, remove old seal with a Seal Puller, place lubricant on inner lip of new seal, install new Seal carefully & do not damage the Output Shaft of Transmission with hammer etc. , reinstall ...

...DRIVE SHAFT IN Vibration is there while driving, increase with transmission speed rather than engine speed. taken drive shafts off and still has the vibration. (Rev engine while in drive have the ...

...drive shaft vibration at around 45mph. It has a 2 piece drive shaft. The large rubber bushing around the drive shaft in carrier housing is somewhat collapsed on the bottom. could this be the problem ...

...drive shaft going to front passenger tire has play (approx 1/8" up, down, front to back) where the drive shaft comes out of the axle sleeve and goes into the wheel hub. no slack in u-joint, no ...

truck? The symptoms described an issue with either tires, steering components, or drive-train components. Take a look at the tires and look for a bubble in the tread or sidewall, irregular tread wear

a grinding noise in the front end of my 2002 f250 super duty and its not the brakes If it is a 2 wheel drive, it is probably your wheel bearings. If it a four wheel drive, it could be the front ...

...truck would shutter bad coming to a stop. Brought it in and said my rear end was bad. I bought used rear end and put it in same thing but worse, pulled drive shaft in rear and drove in 4 wheel drive, ...

truck at an idle 2003 6.0l there is a cataylic converter under there the inside or substrate likes to break in pieces it may be making noises is check engine light on or any exhaust backpressure codes