2000 Ford Focus "remove door lock cylinder outside" Questions

...lock cylinder bezel although it is not necessary to fully remove the screw. Remove the door lock cylinder bezel. Slide the exterior door handle to release. Remove the exterior door handle and

...remove the door handle from inside with 10mm nuts / screws, you need to remove the door panel, google instrucitions, once door panel is off it is simple, make sure you do not disconnect the switch ...

...Remove the door panel and watershield. Remove the service hole cover. Disconnect the door outside opening linkage. Remove the two mounting bolts and remove the door handle if in need of replacement. ...

...remove door pannel and water shield. remove the plastic clips that secures the lock cylinder to the latch rod. slide the lock cylinder clip out of engagement and remove lock cylinder from the door ...

Remove the door trim panel and watershield. Disconnect the rods from the handle and lock cylinder, and from the remote control assembly. Remove the latch assembly attaching screws and remove the latch

door lock cylinder broke remove the trim inside your door .put an old key in the lock to help to pull it out.shine a torch on the inside of your door after removing the trim.you cylinder can be held ...

remove the door trim. Before disconnecting window switch, raise the window all the way up . Now, look inside the door to where the lock cylinder is. You need to unclip the attached linkage to the lock

...Remove the door panel. remove the plastic clip that is attached to the door rod, don't break it. Remove the outside door handle, pull it out. remove the clip that holds the lock cylinder. Remove the ...

...remove door latch Trying to remove door latch on 1995 thunderbird. Car has power locks. inside or outside latch? please rate Section 01-14A: Handles, Locks, Latches and Mechanisms 1995 Thunderbird, ...

...door lock cylinder Take the door panel off. Disconnect the pushrod from the lock cylinder, there should be a retaining washer you have to slide off it. Then there should be a U shaped slide retainer ...