...an Infiniti G20. the grinding or knocking if its coming from the front, is gonna be the tension rod bushings are warn out. get new tension rods for real cheap. thats all i can help with, ...
...good. im thinking its a rod knock but not sure... ????????? Listen to the engine, if the noise is down low it is rod if it is up high it is valves. IF it is rod knock it will eventually throw the
Question about Cars & Trucks
...rod knock or the lifters? I bought it a couple of days ago for 800 bucks. It has a knocking noise that isn't always consistent in volume. It sounds like a combination of lifters and rod knock so I'm ...
...ROD KNOCK,COLUD IT BE A BAD SENSOR OR A BAD HARMACA BALANCER? any codes would show if sensor bad or going bad a rod knock is internal lower engine problem(connecting rod) rod knock can b bearing ...
Question about Dodge Cars & Trucks
...rod knock --where damage to a piston rod either spun bearing ,wrist pin,crack bent causing it to slap on crank or piston cylinder Hello Dixie Home, Generally recognized as a ROD KNOCK... typically ...
Question about Nissan 200SX
...down by the power steering pum You replaced the rod bearings, were they knocking? Also, you have wrist pins that connect the piston to the rod, if one is bad it will knock and sound like a
Question about Nissan 200SX
knocking noise what could it be Internal damage to the engine. Usually a knocking is a loose piston rod that connects to the crankshaft. When the rod bearing gets too worn, it causes the rod to become
...rod knock] and knock usually doesnt throw an engine code and usually fatal to engine will need a mechanic to diagnose how bad or what extent the noise is with engine Piston rod knock. Depends on ...
...Rod knock is not heard at idle. Knock becomes louder as engine speed is increased. Caused by excessive rod bearing clearance. Correct by adjusting rod bearing clearance to .0015 inches by removing ...
...Rod knock is not heard at idle. Knock becomes louder as engine speed is increased. Caused by excessive rod bearing clearance. Correct by adjusting rod bearing clearance to .0015 inches by removing ...
168 questions posted
Usually answered in minutes!
141 Questions
125 Questions
90 Questions
35 Questions
25 Questions