1998 Mazda 626 "brake pads" Questions

brake pads fitted to the front of his car & rear disc machined & new pads. Still has Brake problems & is costing him a lot money and the problem is not being fixed. Problem : When the brake is applied

...brake caliper, unjam the slide, lubricate it and reinstall it. At this point you really need to replace your pads and check your discs for uneven wear and have them machined or replaced as necessary. ...

...pads. rear brakes binding after use of hand brake, cleaned and lubricated hand brake mechnism. found no defect to cable or parts. Front disk pads 60% used +/_ 40% left and rear 80% used +/_ 20% left. ...

than likely the rear disc brakes are worn out. Replace the worn pads before adjusting the hand brake. check the brake pads and if necessary tighten the steel ropes, if it is mechanically driven at all

...brake pads look good as well. no squealing or noise when braking, just not braking well at all. Make sure you have new pads and thick rotors. Then the next step is to make sure fluid reservoir is ...

...brake pads on a 2001 mazda 626? front brake pads need to changed out remove 2 caliper bolts, remove old pads. put new pads in there place, before installing the caliper, be sure to squeeze the piston ...

...brake pads on now and everyone who checks it says they are fine. I bought Mazda brake pads and have not had them installed yet. Will this make a difference? Also is there anything special that should ...

...BRAKE PADS HOW DO I CHANGE THE REAR BRAKE PADS ON A 1998 MAZDA 626 SALOON the best thing you can do is go to an autoparts store and purchase a haynes repair manual for your car. cost about $18, but ...

...brake pads may be getting low, the hand brake is a self adjusting type, so to fix it...with the car turned off, release park brake, pump the brake pedal 10-15 times, it should auto maticly adjust ...

...problem Hi there! Its usually happens when the brake pad are tight on the disk which makes the them touching all the time and the pads are supposed to touch the disk only when your push the