...Use an ohm/volt meter to check the ohm's of the injector, should be about 12.5, but 11 to 15 is in range. Also check the plug, should have 12 volts on one wire with the key on. Let me know. ...
...system and try another fuse like the compressor clutch the pressure switches and plug them back in one at a time til the fuse blows if you have a ohm meter check to see if any part is shorted to ...
Question about Ford Crown Victoria
...are the same plugs. hope you saved the old seats.test your old sensors with a ohm meter then test the new seat sensor to see if they test the same.if they don't you will have to swap out the ...
...meter, using the ohm setting. hook it up to both wires, and look for an open, then a short signal as the rear wheels spin. you will have to jack up the rear end to proform this test to determine if ...
the brake pedal is depressed it activates the switch, which turns on the brake lights. The switch can be tested with an ohm meter or multimeter. If defective, replace. Hope this helped and best wishes
...is running down the battery??? Help! you would need an ohm meter or a test light to figure out what is drawing voltage. you probably have short some where or, just perhaps the ignition switch is
...it with a digital volt/ohm meter that can read a/c voltage. If you want to go further,drop me a line and let me know what equipment you are going to use and I will send you the next steps. ...
...it with an ohm meter (between the ground lead and the car chassis. Wth the key ON, the meter should show a very low resistance to ground. Wth the key off, a very high resistance (or open) to
Question about Ford Crown Victoria
...Ohm Meter) and quickly run through EVERY FUSE in your dash-light-DESTINATION... and their subsequent grounds... Without the "parking lights" issue, I would immediately be pointing at the DASH LIGHT ...
Question about Ford Crown Victoria
.... It can also be tested with a multi meter go to a Ford dealer and ask them to print it out of the manual .It will give you step by step witch connections should have continuity OHM'S in what ...
510 questions posted
Usually answered in minutes!
454 Questions
486 Questions
323 Questions
297 Questions
294 Questions