1997 Nissan Sentra "starter mounting bolts" Questions

Ad

Starter and torque the bolts to 30-37 ft. lbs. (40-50 Nm) Harness connector Connector bracket to the front mount bracket Dipstick tube Transmission into position 4 rear mounting bracket bolts Negative

Ad

bolts through the transmission that thread into the starter. You will need an extension on your 14 swivel socket. Remove both bolts. Disconnect the oil pressure switch wire and wiggle out your starter

Ad

...the car will not start, it make no sound was running fine, just stop had starter replace about 2years ago. It is located below the Intake manifold. transmission end of Engine. Mounted with 2

mounting the starter to the engine. Now, pop open the hood. Get a deep socket, knuckle joint, extensions, etc. From above, you will remove the second and last bolt. If done properly, you should finish

Question about Nissan Sentra

2 Answers

...starter from a 1.6L 1999 Nissan Sentra, Incl. Haynes and Chiltons. Remove the air box top, filter, MAF and duct. Remove the three screw/bolts from the bottom of the air box, and set the box aside. ...

mounting the starter to the engine. Now, pop open the hood. Get a deep socket, knuckle joint, extensions, etc. From above, you will remove the second and last bolt. If done properly, you should finish

...starter motor mounting bolts. Remove battery cable from starter motor. Disconnect harness connector from starter motor harness. Remove starter motor. Everything else I've read states to remove from ...

Question about Nissan Sentra

3 Answers

...starter from a 1.6L 1999 Nissan Sentra, Incl. Haynes and Chiltons. Remove the air box top, filter, MAF and duct. Remove the three screw/bolts from the bottom of the air box, and set the box aside. ...

...starter motor and intake manifold support brackets. Remove the engine drive belts. Remove the alternator and adjusting brackets. Remove the power steering pump and A/C compressor. It is not necessary ...

Question about Nissan Sentra

1 Answer

...mounting bolts. Remove the bolts holding the transmission bell housing to the engine and remove the starter. Unbolt the clutch slave cylinder, and with the help of a friend slide the transmission out ...

Not finding what you are looking for?
1997 Nissan Sentra Logo

624 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...