1985 Nissan 300ZX "change oil sending unit 1990" Questions

...REPLACED SENDING UNIT, SAME ISSUE remove sending unit and install mechanical gauge to see oil pressure psi if psi reads ok- change sending unit again if psi to low less then 6 replace oil pump

...Im driving. It sat for the weekend and no oil drips. Change the oil on Monday needed 2 quarts by Thursday. I have change the valve cover gasket. Check the oil pressure sending unit, it may be

...change oil did not help drove car for 2 to 3 days now light dose not come on any one else have this hapen to them Sounds like the oil pressure sending unit is on it's way out. I hope this helps. Take ...

...change it as my oil pressure light on the dashboard flashes when I stop. OK, first check your Idle and make sure you are within range. The sending unit is on the front left half side of the engine. ...

...like yesturday One of the problems they have had with the 5.7 is a weak oil sending unit. Your would be an electric one if i aint misstaken. Change the sendding unit or change over to a mecanical

...oil has been change recently and is clean. The low oil light is not on. Can you help me with this problem. check the connections at the oil pressure sending unit. It is on the right lower side of the ...

how hard is it to change oil pressure sending unit? 1990 big v 6 your an idiot!

...pump going bad? Could be oil pump, also could be sending unit. When did you last change oil, is oil low? If it's been a while try putting in high mileage oil with higher viscosity, 20w50 for ...

...oil pressure but is there a sensor that could be gone, Yes, the sending unit is the most suspect item, but the correct thing to do is measure the oil pressure with an external "known good" gauge. On ...

...oil pressure sending unit is most likely the culpret easy to change one wire and the unit just screws into the side of the block pick up a new one and you will know what you are looking for on the ...