2001 Pontiac Grand Am SE "intake air temperature sensor" Questions

Ad

intake air temperature sensor located on a 1997 Pontiac Grand Am The intake air temperature sensor is located in the air induction hose. Located between the air filter and the the throttle body of the

Ad

...intake air temperature sensor is almost always mounted on the air intake tube from the air filter housing to the throttle body. It's sometimes mounted on or in the air filter housing. Also note, the ...

Ad

Question about Pontiac Grand Am

1 Answer

...It will start back up after a couple of tries. It will idle normal for 10 - 20 seconds and then idle erratically for 5 seconds. Then back to normal. I would check the intake air temperature ...

...Air Control and crank sensor. See if either one is going bad. Try cleaning the MAF with MAF cleaner or replace it if it's bad. It's usually a process of elimination with cleaning the IAC, MAF or even ...

Question about Pontiac Grand Am

1 Answer

...air intake tube from the throttle body and the exhaust crossover heat shield. Once there out of the way, you can remove one of the bolt and losses the other to slide the thermostat housing off to ...

Question about Pontiac Grand Am

1 Answer

...air intake assembly and top half of the air cleaner assembly. Install the brake vacuum pipe. Fill the cooling system. Connect the negative battery cable, then start the vehicle and verify that there ...

...intake gaskets plugs installed now p0118 code showing and car has stalled three times now and will not start until car sits for a while any suggestions ? . Make sure cooling system is full and purged ...

...intake gasket leak. all those motor have the problem If your engine is overheating, Try this procedure: Dirt and debris can get lodged in the radiator air flow paths. This can block the radiator and ...

Question about Pontiac Grand Am

2 Answers

...air intake manifold, but some housings are on the side or back of the engine. ) How to change the thermostat; Remove the hose from the housing, then remove bolts from the housing and lift the housing ...

air stops re-tighten the bleeder screw.(plastic needs to be removed that says 3800 series on it ) Repeat process until nothing but antifreeze comes out of the bleeder screw & make sure radiator is

Not finding what you are looking for?
2001 Pontiac Grand Am SE Logo

2,566 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Pontiac Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...