push a hard aluminum rod into the hole. The rod must be sliightly scored for the filler to grab on to it. Give it a full 24 hours to cure. Sand it flat, center punch, drill & tap. The new hole will be
...push the pins out at either end. Once the pins are out, slide the plastic covers off. They come off with little to no resistance. There is an aluminum rod with three foam pieces on one end to make ...
Question about Nissan 300ZX
...push the pistons, spin the crankshaft and drive the vehicle down the road. As efficient as today's engines are, they still waste a LOT of the heat energy they produce. The average gasoline engine ...
metal terminals and carbon tracking inside distributor caps. Things to look for when inspecting a distributor cap. If the distributor cap has a mild buildup of dirt or corrosion, it should be cleaned.
Question about Cars & Trucks
...push it out of the way. Then there are two square connectors about half way down on the fire wall each with 1 bolt holding it together. Take out each bolt and jiggle the connector free. If you don't ...
metal pan, fibreglass floorboards, sound deadening components etc.??) I know of no diagram for this are of the Z. Pulling back the carpet and hammering with mini sledge hammer is my suggestion. It'
181 questions posted
Usually answered in minutes!
417 Questions
144 Questions
99 Questions
81 Questions
33 Questions