1994 Buick LeSabre "level 45" Questions

back end of buick lasabre sits high. not leveling out The auto adjustment control has malfunctioned. Shouldnt be too expensive to get fixed though. my 2000 buick lesabre starts for about 30 to 45 mins

...45-75]; when take my foot off gas and quickly re-apply, it smoothes out. Happens quite often-sometimes under load[up-hill], sometimes on level road. Under engine cowl, I found 2 small hoses w/rubber ...

...becomed increasing more pronounced as speed is increased. Worst is between 45 to 50 Plus MPH than levels out but always there. Had a tire repaced aprox1 year ago and thats when issue started. Tech ...

...45-60 when it is decelerating it the car makes a jerking motion and the rpms jump down to 1200 to 1000 then back to 1200 i highly doubt that is normal any suggestions on what it would be? It may be ...

...45 to 65 mph), the car begins one-second surges while climbing hills or if slightly accelerating on a level surface. This does not occur during moderate acceleration or while in lower gears. Already ...

...45 miles per hour a vehicle usually shifts gears into the highest gear so could it be the torque converter hanging up and not shifting quick enough or maybe its the U joints. Have the transmission ...

...level, remove brake fluid to the midway point before proceeding. Raise and support the vehicle. Remove the tire and wheel assembly. Hand tighten 2 wheel lug nuts to retain the rotor to the hub. ...

...level actuator to the valve. Fasten the 2 halves of the air distributor assembly together and torque the fasteners to 13 in-lbs (1.5 Nm). Install the air distributor assembly. Temperature Actuator ...

...45 mph and intermittently at speeds higher than that. I have replaced the spark plugs and wires. Use a bottle of yellow HEET dry gas to remove any moisture problem in the fuel. Check for coolant leak ...

...45*C ATF level is correct and no further action is required. Install new seal and level plug and torque. This completes the ATF check note: If the ATF drips out the hole by the time the temp reaches ...