...Camshaft Position Sensor A Circuit Intermittent) as a problem it's having... I replaced the camshaft sensor about 2 years ago when I was having a similar problem; could the sensor have gone out, or ...
Question about Dodge Stratus
...Camshaft position sensor). Need to have the timing belt replaced. If the engine was also washed at the car wash, that can also cause problems at times. If so, try getting a hold of an air blower and ...
camshaft position sensor for a 2.4L 2005 dodge stratus i need to know where it is located and how to fix it. thank you THE CAMSHAFT POSITION SENSOR IS LOCATED ON THE LEFT SIDE OF THE HEAD. 2 BOLTS AND
...position sensor )---mechanical fault code p 0340 refers to -camshaft (CMP) sensor A bank 1 circuit malfunction ===causes wiring--CMP sensor--ECM cosrs nothing to check the timing belt , just remove ...
Question about Dodge Stratus
...Camshaft Position Sensor causing problems (I My car is a 2005 Dodge Stratus Sedan with the 4 cyl DOHC engine. The first symptom was an engine light and a loose vacuum tube. When I checked out the PCV ...
Question about Dodge Stratus
...camshaft and crankshaft position sensors on 2005 dodge stratus the check engine light still on and reading the same codes are bad what should i do did you clear the codes? Try unhooking battery for a ...
...Camshaft Position Sensor Replacement - Bank 2 (Left Side) Exhaust Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake Camshaft Position Sensor Replacement - Bank 1 (Right Side) Exhaust ...
...replace a part you may or may not need . Why ? What code ? Does the vehicle run ? There has been a lot of confusion on these vehicles with variable valve timing , mixing up cam sensors with camshaft ...
...replace both right bank sensors with bosch parts. On a "OBD" scan I get the 1/4 code P0016 2/4 code P0017 3/4 code P0016 and 4/4 code P00017. In the scan mode on my code reader I get 1/2 DTC 1208 ...
...replace. It depends on the code , is it a circuit high or circuit low code this could be a shorted wire or grounded or an internal sensor problem . P001A "A" Camshaft Profile Control ...
1,656 questions posted
Usually answered in minutes!
1,417 Questions
924 Questions
772 Questions
621 Questions
528 Questions