...inner tie rod Does anyone know what size socket is needed to remove the bolt and also what the torque is? Thanks, Troy To Steering Gear Bolt 90 Nm (66 ft. lbs.) Jam Nut 75 Nm (55 ft. lbs.) NUMBER: ...
...the outer tie rod end nut that is connected to inner tie rod. Pull tie rod end back out of knuckle. Use pliers or vise grips to hold inner tie rod end while turning outer tie rod end to the
...Inner Tie Rod Bushings. The inner tie rods are up on the firewall behind the engine, have someone turn the steering wheel back and forth (just enough to feel all the play) and see if the rods are ...
...inner tie rod on a 2000 dodge intrepid I did this on a 2002 Intrepid, and found that it wasn't too complicated. I replaced the bushings only, rather than the tie rod end. You can get bushing ...
...inner tie rod ends. Loosen both. Remove one at a time, replace bushing with kit. Use some synthetic brake grease on the bushings. I recommend Napa sylglide. Replace the bolt, but do not tighten all ...
...inner tie rod bushings you need to get it out. get on the engine and go to the back at the fire wall look for the bolt that hold the tie rod there should be a lock washer which is bent to keep the ...
...inner tie rod ends, stabilizer bar bushings, lower control arm bushings , and finally a wheel alignment ,you have some bad looseness in one or more of these front end parts. GOOD LUCK FRIEND. 30 ...
bushings worn out where control arms connect to rack & pinion Those are available from any parts store. Inner tie rod bushings.
inner tie rod bushings, the small round ones that go inside the tie rod, there is a metal plate with 2 holes that goes onto it and a fastener lock plate. The factory bushings can be hell to install. I
How do you replace the inner left tie rod bushings on a 98 dodge intrepid? Took it to my friend who is a mechanic - problem solved.
1,180 questions posted
Usually answered in minutes!
1,166 Questions
924 Questions
766 Questions
627 Questions
548 Questions