Dodge Caravan 1996 How do I install a crank shaft position sensor No trick. remove and replace. Front of engine aound 11:00 position at crank pully
Question about Dodge Caravan
crank pulley slightly to correct) 3. Install the sensor - slide it in to touch the sensor ring - tighten the bolt. 4. plug the sensor back into the harness The spacer/felt pad will space the sensor at
position sensor, computer.Voltage is correct at coil pack. OBD II checked out with no errors is the idle air control solenoid next to the air intake tube good. did you relearn the cam and crank sensor
...crank and cam sensor new coil pack new flexplate still no spark, scannner show sync problem, any ideas If you have replace new cam sensor with no sparks and the coil are good putting out 12 volt, my ...
...Crank sensor located? How do i get to them? which one would be the one that doesn't cause the spark so the engine wont start. i have both parts but boiled the problem down to these two sensors but ...
...crank position sensor and last try moving the plugs aroud to see if the code changes or if you get a new one,i dont think you will be stranded but the engine performance is crapy. It probably is as ...
...electrical connector to the wiring harness connector. Attach connector to heater tube bracket. Install speed control servo. Tighten nuts to 9 N·m (80 in. lbs.) torque. crank shaft position ...
crank sensor is CRANKSHAFT POSITION SENSOR - 3.9 - 5.2 - 5.9L ENGINES REMOVAL The sensor is bolted to the top of the cylinder block near the rear of right cylinder head Note: The sensor is accessed by
Question about GMC Cars & Trucks
...crank sensor at the front under the front crank pulley and it is in the correct installed position, you should not have a code for that,unless the wiring is defective or the crank sensor is
1,791 questions posted
Usually answered in minutes!
Step 2: Please assign your manual to a product: